Boom pump
- Hourly$200 to $255/hr
- Per yard pumped$4.00 to $4.50/yd
- Typical minimum job$800 to $1,300+
The honest version: published rate ranges for Huntsville and Madison County, the factors that move a quote, and worked examples with the math shown. Use it to sanity check any number you get, including ours.
Ballpark ranges from published 2025 to 2026 US rate guides. Pump size, yardage, distance, and schedule move the real number. The operator confirms the final price before anything is booked.
1. Pump type and size. A line pump is the cheaper truck. A boom costs more, and bigger booms cost more than smaller ones. Right sizing is the whole game, which is why reach and access details matter.
2. Yardage. More yards is more per yard charges and usually more hours. It also makes you a better job: operators would rather pump 60 yards once than 15 yards three times.
3. Time on site. Minimums run 3 to 4 hours. Slow ready-mix, unfinished forms, and late inspections all turn into billed time.
4. Travel. A job across the market from the truck's last pour carries travel. Jobs near other scheduled work quote better.
5. Access and setup. Tight access, long hose runs, soft ground, and overhead lines all add planning and sometimes a different truck. None of it is a surprise if it is in your request.
6. Schedule pressure. A pour booked a week out rides the normal board. A pour needed tomorrow takes whatever truck is left, at whatever that costs.
7. Washout and extras. Washout handling, extra hose, and standby are real costs. Good quotes list them up front. Bad surprises come from quotes that never mentioned them.
Example 1: 40 yard house slab, line pump. Four hours at about $160 is $640, plus 40 yards at about $4.50 is $180. Total about $820, above the roughly $600 line pump minimum, so the hourly plus yardage math is the quote.
Example 2: 50 yard slab, boom pump. Four hours at $225 (mid range) is $900, plus 50 yards at $4.25 is about $213. Total about $1,113, inside the typical $800 to $1,300 minimum band for smaller boom jobs and consistent with it for a half day pour.
These are illustrations from the published ranges on this page, not quotes. Your operator confirms the real number for your job, your date, and your site.
Send yardage, the pour type, the farthest reach or hose distance, access notes, and a firm date in one request. That is exactly what the form below asks for, and it is why operators can price from it without a site visit on most residential and light commercial jobs.
Most Huntsville area boom pump jobs start between $800 and $1,300 for the minimum, then run $200 to $255 per hour plus $4.00 to $4.50 per yard pumped. Line pump jobs start around $600, at about $160 per hour plus about $4.50 per yard. Your quote depends on pump size, yardage, and how far the truck travels.
Pump size, travel distance, schedule pressure, and how complete your job details are. An operator quoting blind pads for the unknowns. A request with yardage, reach, access notes, and a firm date gets a tighter number because there is less to pad for.
Travel beyond the local area, extra hose beyond the standard setup, standby time when ready-mix runs late, and washout handling. A good quote lists them before the job. Ask for them in writing if they are not on it.
Often, yes. Operators route trucks by area and day. A pour that can slide a day can ride along with another job nearby instead of paying for a dedicated trip, and that shows up in the quote.
Done with ballparks? Send the job details and get the real number for your pour, your date, and your site.